Safety Instructions - Kärcher RC 3.000 Originalbetriebsanleitung

Warranty
The warranty terms published by the relevant sales
company are applicable in each country. We will repair
potential failures of your appliance within the warranty
period free of charge, provided that such failure is
caused by faulty material or defects in manufacturing. In
the event of a warranty claim please contact your dealer
or the nearest authorized Customer Service centre.
Please submit the proof of purchase.
(See address on the reverse)

Safety instructions

– Please read the operating in-
structions for your machine
before using it, and pay par-
ticular attention to the follow-
ing safety instructions.
– Warning and information
plates on the machine pro-
vide important directions for
safe operation.
– Apart from the notes con-
tained herein the general
safety provisions and rules
for the prevention of acci-
dents of the legislator must be
observed.
Electric components
DANGER
 Never touch the mains plug
and the socket with wet
hands.
 Check the power cord with
mains plug for damage prior
to every use. Immediately
have damaged power cord
replaced by an authorised
customer service / electrician.
Do not operate an appliance if
the power cord is damaged.
 Turn off the appliance and re-
move the mains plug prior to
any care and maintenance
work.
 Repair works may only be
performed by the authorised
customer service.
 Do not use abrasives, glass
or universal cleaners! Never
immerse the appliance in wa-
ter.
 Do not remove the mains plug
from the socket by pulling on
the power cord.
 Do not scrape the power cord
across sharp edges and en-
sure that it does not get
pressed.
 Do not carry / transport the
appliance on the mains cable.
WARNING
 The appliance may only be
connected to an electric sup-
ply that has been installed by
an electrician in accordance
with IEC 60364.
 The appliance may only be
connected to alternating cur-
rent. The mains voltage must
correspond with the voltage
indicated on the type plate.
 For safety reasons, we rec-
ommend that you operate the
appliance only via a residual
current device (max. 30 mA).
 Completely pull the power
cord out of the appliance or
completely uncoil it upon op-
eration.
Tips for charging the charging
station and the cleaning robot
– The charging device located
on the station must only be
used to power the cleaning
robot.
– 6
EN 19