Operation - thomann Omnitronic MZD-88 Bedienungsanleitung

8. OPERATION

1. Prior to switching on, set all LEVEL controls to mid-position to avoid damage to the hearing by a volume
which is too high when switching on.
2. Switch the device on via the power switch. The power indicator on the front panel lights up. Switch on the
connected units; always switch on your PA amplifier last.
3. Adjust the desired volume ratio with the LEVEL controls.
4. Determine the balance of the input signal between the left and right output.
5. Switch off the unit with the POWER switch after operation.
The figure shows the signal of CH 1 routed to each pair of stereo outputs. To add signal from the CH 2
input to the STEREO A outputs, use the level controls in the same zone (STEREO A / OUT 1-2) in the
second row CH 2.
Create stereo mixes with the LEVEL and PAN controls on the front panel of the MZD-88. Each row on the
front panel (e.g. CH 1) corresponds to one input. Each zone on the front panel (e.g. STEREO A / OUT 1-2)
corresponds to a pair of stereo outputs. Use the the LEVEL control to add signal to each pair of stereo
outputs. Use the PAN control to balance the signal between the left and right output.
21/23 00033027.DOC, Version 1.0