Canon imageRUNNER 1740i Anwenderhandbuch Seite 58

● To automatically assign an IP address using DHCP, RARP or BOOTP:
❑
Press [DHCP], [RARP], or [BOOTP].
NOTE
'DHCP' is selected as default.
❑
Enter the IP address, subnet mask, and gateway address.
NOTE
For more information on the IP address settings, see Chapter 2, "Connecting the
Machine to a TCP/IP Network," in the System Settings Guide.
7
8
NOTE
After restarting the machine, you might want to check if the IP address is correctly set
to the machine. For help, see "Checking the Machine's IP Address," on p. 6-4.
Press [OK] to finish the initial
setup.
From the next time the machine's main
power is turned ON, the Setup Guide does
not appear.
If you want to return to the previous screen,
press [Back].
Press [Yes] to restart the
machine.
If the IP address settings have been
specified, restart the machine to make the
settings effective. Press [No] if you want to
manually restart the machine later. (See
"Restarting the Machine," on p. 5-12.)
Turning ON/OFF the Machine
2
2-21