Operation; Dry Vacuum Cleaning; Wet Vacuum Cleaning - Kärcher MV 5 Originalbetriebsanleitung

Operation

Caution
Always work with an inserted flat
fold filter - during wet as well as

dry vacuum cleaning!

Before Startup
Illustration

Remove the appliance head and take
the contents out of the container.

Turn the container, press in the
steering roller in the openings at the
base of the container till the end-
point.

Insert and lock the appliance head.

Clip the holder for the accessory
compartment onto the rear side of
the appliance.
Start up
Illustration

Connect accessories.
Illustration

Plug in the main plug.
Illustration

Turn on the machine.
Dry vacuum cleaning
Caution
Work with a dry flat fold filter only.
Check the filter for damage prior
to installation and replace as
necessary.
Illustration

For vacuuming dry dirt an additional
filter bag can be inserted if neces-
sary.
Caution
Only operate the filter cleaning
without a filter bag inserted, oth-
erwise the filter bag can get
damaged.
Information filter bag
The filling level of the filter bag de-
–
pends on the dirt that is sucked in.
The filter bag needs to be replaced
–
more frequently while sucking in
fine dust, sand, etc.
Clogged filter bags can burst -
–
therefore make sure to replace the
filter bag in a timely manner!
Caution
Vacuum cold ashes only when
using a pre-filter.
Order no. basic design: 2.863-139.0,
premium design: 2.863-161.0.

Wet vacuum cleaning

Caution:
Immediately switch the appli-
ance off or pull the power plug if
foam forms or liquids escape!
Do not use a filter bag!
Note: If the container is full, a float
closes the suction opening, and the ap-
pliance works at a higher speed.
Switch off the appliance immediately,
and empty the container.

For vacuuming up moisture or wet-
ness pay attention to the correct
floor nozzle setting and connect the
corresponding accessories.
Working with electrical power

Adapt the adapter to the connection
diameter of the electric tool using a
knife if necessary.
Illustration

A) Plug the enclosed adapter onto
the handle of the suction hose and
connect the electric tool with the
connection.
EN
– 10
tools
21