Accessories; Technical Data - Hilti PM 2-LG Bedienungsanleitung

Laser beam
en

3 Accessories

Designation
Target plate
Wall mount for the magnetic holder
Magnetic holder
Tripod

4 Technical data

Right of technical changes reserved.
Range of the lines and intersection point
Accuracy
1
Self-leveling time
Laser class
Line width
Self-leveling range
Automatic power-off
Operating status indicator
Power supply
Battery life
Operating temperature
Storage temperature
Dust and water spray protection (except battery com-
partment)
Tripod thread (tool)
Weight
Dimensions
1 Influences such as particularly high temperature fluctuations, dampness, shock, dropping, etc. can affect accuracy. Unless stated
otherwise, the tool was adjusted or calibrated under standard ambient conditions (MIL-STD-810G).
12
Blinks twice every 10
seconds (pendulum not
locked) or every 2 seconds
(pendulum locked).
Blinks five times and then
remains on permanently.
Blinks with a high frequency.
Blinks every 2 seconds.
Short designation
PRA 54
PMA 82
PMA 83
PMA 20
20 m (65 ft)
±3 mm at 10 m (±0.12 in at 33 ft)
3 s (typical)
Class 2, visible, 510 - 530 nm, ±10 nm (EN 60825-
1:2007 / IEC 60825 - 1:2007); class II (CFR 21 §1040
(FDA)
Distance 5 m: < 2 mm
±4° (typical)
Activated after: 1 h
LED and laser beams
AA‑size batteries, Alkaline batteries: 4
Alkaline battery 2,500 mAh, Temperature +24°C
(+75 °F): 8 - 14 h (depending on the number of lines
switched on)
Min. -10°C / Max. +50°C (+14 to 122 °F)
Min. -25°C / Max. +63°C (-13 to 145 °F)
IP 54
in accordance with IEC 60529
UNC¹⁄₄"
Including battery: 520 g (1.15 lbs)
65 x 107 x 95 mm (2 ¹/₂ x 4 ¹/₄ x 3 ³/₄ in)
The batteries are almost exhausted.
Automatic power-off has been deac-
tivated (see section "Deactivating the
automatic power-off function".
The tool is unable to level itself (outside
the self-leveling range).
Inclined line operating mode. The pen-
dulum is locked, as a result of which the
lines are not leveled.