T1 T2 T1-T2" Second Display Input Selection; K/J" Second Display Input Thermocouple Type Select; Hi/Lo Limits" Mode; Wireless Mode (Tmd-53W Only) - Amprobe TMD-53 Bedienungshandbuch

"ENTER" key to store the Hi Limit value.
"= = = =.=" is displayed in main display, Lo Limit
value is entered via overlay numbers, then press
overlay "ENTER" key to store the Lo Limit value and
exit SET mode.
4. When the thermometer is turned on it uses the
relative value and Hi/Lo Limits values that were
entered when thermometer was last in use.

"T1 T2 T1-T2" Second Display Input Selection

The input selection indicates which input is selected for
second display; T1 thermocouple, T2 thermocouple or
the difference between the two thermocouples (T1-T2).
When the thermometer is turned on, it is set to T2 input.
To select a different type of thermocouple use the "K/J"
key.
"K/J" Second display Input thermocouple type
select
The "K/J" key for T2 input selects K-type or J-type
thermocouple as input, when the second display has T2
shown. When the thermometer is turned on, it is set to
the type selected when the thermometer was last turned
off.
"Hi/Lo LIMITS" Mode (only Main display)
Press "Hi/Lo LIMITS" key to enter the Hi/Lo Limits
comparative mode, "
temperature value exceeds the Hi or Lo Limits value, the
beeper emits a continuous or pulsed tone. Press "Hi/Lo
LIMITS" key again to exit the Hi/Lo Limits mode.
Wireless Mode (TMD-53W)
Press the " " key for more than two seconds to start
wireless function. Press the " " key again for another
two seconds to stop wireless function. The wireless mode
will shut down if there is no wireless signal for two
minutes.
" is displayed. When the input
8