Maintenance - Makita BUB142 Betriebsanleitung

• To remove the battery cartridge, withdraw it from the
tool while pressing the buttons on both sides of the car-
tridge.
• To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click. If not, it may accidentally fall out
of the tool, causing injury to you or someone around
you.
• Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
Switch action
CAUTION:
• Before inserting the battery cartridge into the tool,
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop. (Fig. 2)
Air volume adjusting dial
Air volume can be adjusted to any of three settings by
turning the adjusting dial with the switch trigger fully
depressed. Refer to the table below for the relationship
between the number on the dial and the air volume.
Number on the dial
3
2
1
CAUTION:
• Use the adjusting dial only after the switch trigger
returns to the "OFF" position. Turning the dial before
the trigger returns may damage the tool.
• If the tool is operated continuously until the battery car-
tridge has discharged, rest the tool for at least 15 min-
utes before proceeding with a fresh battery.
ASSEMBLY
Blowing
For dust blowing, attach nozzle to blower outlet, turning
clockwise to lock it in place. (Fig. 3)
Dust suction (Fig. 4)
For dust suction, fit nozzle onto suction inlet and dust bag
onto blower outlet.
After the bag fills with dust, empty the contents of the dust
bag into a dust bin by releasing the fastener. (Fig. 5)
CAUTION:
• Empty the dust bag before it becomes too full, or the
suction force weakens.
4
Air volume
High
Medium
Low

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and the bat-
tery cartridge is removed before attempting to perform
inspection or maintenance.
Cleaning
From time to time, wipe off the outside of the tool using a
cloth dampened in soapy water. Never use gasoline, thin-
ner or the like, or discoloration and/or cracks can take
place. (Fig. 6)
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Nozzle
• Dust bag
• Corner nozzle
• Straight pipe
• Flexible hose
• Joint
• Various type of Makita genuine batteries and chargers
EC-DECLARATION OF CONFORMITY
Model; BUB142, BUB182
We declare under our sole responsibility that this product
is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 2004/108/EC, 98/37/EC.
Tomoyasu Kato
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
CE 2007
Director
ENH101-7