Operation; Before Operation - FLORABEST IAN 275925 Handbuch

Always remove the plug from the
■
power socket during work breaks,
when adjusting the appliance (e .g .
changing nozzles) and when it is
no longer in use .
Keep the nozzle at a distance from
■
the workpiece or the area being
processed . A build-up of hot air can
result in damage to the appliance .
The appliance must always be
■
kept clean, dry and free from oil or
grease .
Never use the appliance for purpos-
■
es other than the ones for which it
was designed .

Operation

Before Operation

Mount the device
HINWEIS
► The cable must be routed in the device as
shown in figure A . Insert the cable with a
loop into the unit . It must not exceed the
housing of the appliance . The cover of the
housing must be easy to install . Make sure
that the cable is not pinched .
♦ Place the cover on the device and screw it with
the supplied mounting screws (see Fig . A) .
Mount the stand
♦ Attach the stand
Operation
♦ Push the loop of the extension cable into the
provided strain relief
fix it to the bar provided .
♦ Connect the appliance to a power socket (230
V alternating current) using an extension cable .
FUV 2000 A1
IB_275925_FUV2000A1_LB6.indb 5
to the unit (see Fig . B) .
in the handle and
♦ Switch the appliance on by pressing the ON/
OFF switch . The full operating temperature is
reached after approx . 1 minute .
♦ To kill weeds, now place the cone nozzle
onto the plant to be treated for around 5-10
seconds depending on the type of plant .
♦ For taller plants, first only heat the upper section
of the plant briefly and then place the cone noz-
zle against the shrunken plant for approx .
5-10 seconds .
NOTE
► This appliance is particularly suitable for
removing weeds .
► Weedkilling is most effective at an early
stage of vegetation growth .
► The most suitable time is during spring .
► The treatment is at its most intensive the
younger the plant is . However, the success
of the measure is not immediately visible .
The visible section of the plant can also be
burnt off with a longer exposure time/treat-
ment .
► Plants do not react immediately to the heat ra-
diation with the recommended treatment time .
The following applies as a basic principle:
young, soft-leaved plants react most sensit-
ively to treatment . They are subsequently no
longer capable of survival .
► Older plants with hard leaves such as thistles
must be treated more frequently at an interval
of between 1 and 2 weeks in order to make
them dry out .
Winter-green grasses are extremely robust
and require longer treatment .
► To begin with, overgrown areas must be
treated several times at short intervals in
order to produce long-term success . After this,
treatment at longer intervals is sufficient .
► Burning the plants off completely is not essen-
tial . During heating, the leaf cells dry out and
the weed will die .
► Repeated treatment of certain types of weed
may be necessary .
GB │ IE │ NI │ 5 ■
03.02.17 08:46