Installation - Oase FiltoClear 20000 Gebrauchsanleitung

Pos: 202 /Alle Produkte/Überschriften/H2 Symbole auf dem Gerät @ 21\mod_1292588857121_121.doc @ 127058 @ @ 1
Symbols on the unit
Pos: 203 /Alle Produkte/Symbole/Warnsymbole auf dem Gerät @ 21\mod_1292602924329_121.doc @ 128263 @ @ 1
D
The warning symbols on the unit have the following meaning:
Risk of personal injury if used incorrectly
Incorrect use of the unit can cause injury or damage to assets. Always read the instructions for use first.
Risk of personal injury caused by a general source of danger
Dangerous UVC radiation. Health hazard for eyes and skin caused by light flash. Only operate the UV-C
lamp inside the housing.
Pos: 204 /Alle Produkte/Symbole/Gebrauchssymbole auf dem Gerät @ 21\mod_1292602602499_121.doc @ 128230 @ @ 1
Symbols
The symbols on the unit relating to its use have the following meaning:
Protected against touching dangerous components. Splash water protected.
Protect from direct sun radiation.
Dismantle at temperatures of 0 °C and below.
Pos: 205 /Alle Produkte/Dummy_module/Abstand 6 pt @ 7\mod_1196627997106_0.doc @ 41651 @ @ 1
Pos: 206 /Alle Produkte/Überschriften/H1 Aufstellung @ 21\mod_1292589436499_121.doc @ 127085 @ @ 1

Installation

Pos: 207 /Alle Produkte/Bildbezeichnungen/Bild (A) @ 21\mod_1292580791831_121.doc @ 126311 @ @ 1
Figure (A)
Pos: 208 /Filter/FiltoClear 20000/30000/Aufstellung planen für FiltoClear 20000/30000 @ 21\mod_1292589741392_121.doc @ 127112 @ @ 1
To be taken into consideration for planning:
− Spacing between unit and water: min. 2 m (safety spacing!).
− Do not expose the unit to direct sun radiation.
− Water return point. OASE recommend: Route the return hose such that the clean water is indirectly returned to the
pond, e.g. through a water course. In this manner it will be additionally enriched with oxygen.
− Height difference between filter lid and water return point: max. 2 m.
Pos: 209 /Filter/FiltoClear 20000/30000/FiltoClear 20000/30000 eingraben, ebenerdig aufstellen, an T.pumpe anschließen @ 21\mod_1292590261476_121.doc @ 127139 @ @ 1
Installation possibility 1: Bury close to the pond.
Dig a hole close to the pond and place the container into the hole up to the mark (B 11).
Installation possibility 2: Placement close to the pond.
Place the unit close to the pond where it is flood protected (e.g. hidden behind shrubs). The ground must be firm and
level.
Connecting a filter pump
A filter pump is required to operate the pressure filter (only contained as a set in the scope of delivery). Only connect to
the pump by means of pressure hoses approved for at least 0.2 bar or the maximum pump pressure.
Hoses with an internal diameter of 1 1/2" or 2" can be connected to the unit.
Pos: 210 /Alle Produkte/Dummy_module/===== Seitenwechsel ===== @ 0\mod_1125648978015_0.doc @ 1631 @ @ 1
- GB -
21