Operation; Simple Operating Functions; Device Led Feedback - HomeMatic HM-RC-Sec3HM-RC-Sec3-B Bedienungsanleitung

7

Operation

7.1 Simple operating functions

After teaching, simple operating functions are
available.
HM-RC-4:
The 4 buttons are taught as 2 separate button pairs
(ON/OFF) for the receiver upon delivery, depending
on from which pair the button was pressed for
teaching. Switch actuators and dimmers can then
be switched ON/OFF or dimming occurs by holding
the button pressed.
The blind actuators move up or down.
HM-RC-Sec3, HM-RC-Sec3-B:
The behavior should only be managed with the
configuration software from the center. In factory
status, the remote control behaves like a button pair
(see above) and like an "ON" button.
HM-RC-P1:
In factory status, configured when teaching as an
"ON" button.
36
HM-RC-Key3, HM-RC-Key3-B:
Operating the Keymatic. In factory status, the
remote control behaves like a button pair (see
above) and like an "ON" button.

7.2 Device LED feedback

The feedback signals apply for operation with and
without the center.
No actuators have been taught yet:
Brief press of the button: LED is illuminated in
orange for 1 second
Extended button press: LED is illuminated in orange
for 1 second
Button held down: LED is illuminated as long as the
button is pressed and goes dark afterward
Actuators are taught:
Brief/long press of the button: LED is illuminated
in orange as long as the function transfer requires,
this time depends on the number of actuators that
have been taught for this button, the number of
required transmission attempts and the encoding
and transmission mode. After the radio transmission
is complete, the LED is illuminated in either red or
37