Abicor Binzel G3000 Originalbetriebsanleitung Seite 30

12 Disposal
12 Disposal
12.1 Materials
EN - 14
NOTICE
• Dismounting may only be carried out by qualified personnel (in Germany
see TRBS 1203).
• Please also consult the operating instructions for the welding components,
such as power source, compressed air line.
• Observe the information given in the following chapter:
 8 Putting out of operation on page EN-11.
1 Cut off hose and power cord.
2 Remove parts to be disconnected.
When disposing of the system, local regulations, laws, provisions, standards
and guidelines must be observed. Please observe the regulations on the
disposal of electronic scrap and dispose of this at your local waste disposal site
(e.g. recycling centre).
For the product to be properly disposed of, it first must be dismounted. Please
take note of the following information:
 11 Dismounting on page EN-13
This product consists for the most part of plastics, steel and non-ferrous metals.
Steel and non-ferrous metals can be molten in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are marked in
preparation for sorting and separation of the materials for later recycling.
Gouging torch G3000/G4000