Technical Data; Information About The Batteries; Installation Of The Wall Holder - Silvercrest SAS 7.2 A1 Bedienungsanleitung

Technical data

Power adapter 4
Input voltage:
Output voltage :
Protection class:
Type designation:
a a p p p p l l i i a a n n c c e e
Input voltage:
Battery:
B B a a t t t t e e r r i i e e s s
Capacity:
Batteries:

Information about the batteries

1. This hand vacuum cleaner is operated by recharge-
able Ni-MH batteries.
Before using the cableless hand vacuum cleaner
for the first time, the batteries must be charged
for at least 24 hours.
2. The batteries reach their full capacity after a
charging period of 24 hours. For care of the bat-
teries we recommend the following: after the bat-
teries are charged, remove the power adapter
4 from the mains power socket. Reconnect the
power adapter 4 again with the mains power
socket when the suction power of the appliance
is noticeably weaker.
100 - 240 V ~
50/60 Hz
200 mA
10 V
200 mA
II
HK-S-100A020-EU
10 V
200 mA
7,2 V
1300 mAh
6 x 1.2 V Sub-C
Ni-MH
HR14/HRM 26/50

Installation of the wall holder

Mortal danger!
Ensure that there are no power cables or other con-
duits or pipes in the wall at the location where you
intend to bore the holes for the wall holder 3.
It would be a potentially fatal risk to bore into a
current carrying electric cable!
1. Place the barrel plug 5 of the power adapter 4
into the wall holder 3 as shown in the diagramme.
Secure the barrel plug 5 by turning it.
2. Select a suitable installation location for the wall
holder 3: It should present no problem with
taking the hand vacuum cleaner out of it and a
mains power socket for the power adapter 4
must be accessible.
3. Bore two holes with a spacing of approx. 58mm.
Use the wall holder 3 to mark the boreholes:
this will ensure the spacing is correct. The bore-
holes must be suitable for 5 mm wallplugs.
4. Insert the wallplugs into the boreholes and, using the
screws, firmly screw the wall holder 3 to the wall.
5. You can place the nozzles on the lateral acces-
sories holder.
6. Connect the power adapter 4 to a mains power
socket.
- 4 -