Led Pattern; Switch Function; Speci¿ Cations - Mitsubishi Electric MAC-557IF-E Installationshandbuch

5. LED pattern

:ON :OFF :Blinking
Power is ON or software downloaded
ALL settings reset
WPS activated (PBC)
WPS activated (PIN)
WPS enabled
WPS failed
Server and access point communication connected, and
air conditioner communication failed
Server and access point communication connected, and
air conditioner communication connected
Server and access point communication connected, and
air conditioner communication starting up
Server communication failed, and air conditioner
communication connected
Server communication or access point communication failed, and
air conditioner communication starting up
Server communication or access point communication failed, and
air conditioner communication failed
Access point communication failed, and
air conditioner communication connected
Access point communication failed, and
air conditioner communication starting up

6. Switch Function

(1) WPS switch
The WPS switch is used for pairing the Wi-Fi interface with the access point. There are two types
of WPS: push button configuration (WPS-Push) and PIN code method (WPS-PIN).
WPS-Push
Hold down the WPS switch for 2 seconds to start WPS-Push pairing.
When WPS-Push is enabled on the Wi-Fi interface, LED1 starts flashing green (0.5-sec interval)
and the pairing can be completed by enabling WPS-Push on the access point.
WPS-PIN
Hold down the WPS switch for 15 seconds to starts WPS-PIN pairing.
When WPS-PIN is enabled on the Wi-Fi interface, LED1 starts flashing green (0.2-sec interval)
and the pairing can be completed by enabling WPS-PIN on the access point.
Before using WPS-PIN, the PIN code of the Wi-Fi interface needs to be set on the access point.
This product is only compatible with the access point that supports WPS.
(2) RESET switch
Hold down the RESET switch for 2 seconds to reboot the system.
Hold down the RESET switch for 15 seconds to initialize the Wi-Fi interface to the factory default.
When the Wi-Fi interface is reset to the factory default, ALL the configuration information will
be lost. Take great care in implementing this operation.
7. Specifications
Input Voltage
Power consumption
Size W×H×D (mm)
Weight
RF channel
Radio protocol
Encryption
Authentication
Description
DC12.7V (from indoor unit)
MAX 2W
88×49×18.5
105g (including cable )
1ch ~ 13ch
IEEE 802.11b/g/n (20)
AES
PSK
LED1 LED2
(0.5-sec interval) (0.5-sec interval) (0.5-sec interval)
(0.5-sec interval)
(0.2-sec interval)
(5-sec)
(once every 5 sec) (0.5-sec interval)
(once every 5 sec)
(once every 5 sec)
(0.5-sec interval) (once every 5 sec)
(0.5-sec interval)
(0.5-sec interval)
LED3
(5 sec)
(once every 5 sec)
(once every 5 sec)
5