How To Clean And Store - Tribest SW-1000 Bedienungsanleitung

1. Please turn on the Slowstar and pour 1~2 cups of water into the Feeding Chute to clean out most
of the pulp remaining in the housing.
2. Disassemble the parts.
3. Clean the disassembled parts under running water using the cleaning brush.
• Do not use a steel brush, abrasive solvent, or harsh cleaning agent.
• Do not use an automatic dishwasher or dish dryer.
4. Do not clean the Main Body with running water. Clean the Main Body with a damp, soft towel.
5. After cleaning each part, dry each part completely, and place it on a clean surface.
TIPS:
1. Order of Disassembly and Assembly
• Disassembly:
1) Disassemble the Feeding Chute Assembly by rotating it counter-clockwise.
2) Disassemble the Duoblade Auger Housing by rotating it counter-clockwise.
3) Separate all parts in the Auger Housing.
4) Clean all juicing parts using the Cleaning Brush under running water.
5) Dry all parts completely.
• Assembly:
1) Assemble the Auger Housing on the top of the Main Body by rotating it clockwise.
2) Install the Pulp Wiping Assembly inside of the Auger Housing.
3) Insert the Juicing Screen into the Pulp Wiping Assembly.
4) Insert the Duoblade Auger into the Juicing Screen.
5) Assemble the Feeding Chute Assembly on top of the Auger Housing by rotating
it clockwise.
2. If the Feeding Chute Assembly lid does not open after operation.
• Press the switch to the 'REVERSE' position 2~3 times first, then press the switch to the 'ON'
position to remove any residue that may be stuck between the Auger Housing and Lid.

HOW TO CLEAN AND STORE

EN
15