Configure Analog Connection - Auerswald Analog/ISDN Converter Installations- Und Bedienungshandbuch

As the Analog/ISDN Converter starts to transmit
the last digit after the expiration of the configured
time to the central office, select this times as short
as possible.
The standard time for manual entries is approx.
3 seconds. If telephone numbers are only dialled
en bloc (e.g. devices with automatic speed dialling
key), the time may be lower.
To shorten the delay time between the
last digit and the connection setup, you
Analog Line 1 and 2: Enter the external tele-
phone numbers of both analog connections (if two
exist), so that they can be presented correctly by
the connected PBX (e.g. in the call charge man-
agement and in the display of internal telephones).
Disabled: Activate this setting to select the
unused analog input if the Analog/ISDN Converter
is connected to a single analog connection only.
Overflow: Activate this setting to guarantee a
higher availability of the exchange lines. If the

Configure Analog Connection

Configuration, PC Program
can always terminate a telephone number dialling
with a # (hash). The Analog/ISDN Converter rec-
ognizes this sign as the end of a dialling.
If the destination number is part of a Point-to-Point
connection, it may happen that the call will be redi-
rected by the remote PBX after 4 seconds to the
reception. To prevent this problem, you have to
configure the time to less than 4 seconds.
selected line is busy, the other analog connection
will be used (if it is not busy).
You have to assign these telephone
numbers as MSN or DDI on the exter-
nal ISDN connection of the PBX.
These are used by the PBX e.g. for the call distri-
bution and to select the exchange line.
Dialling mode: Select the dialling mode used by
the network provider.
The features 3PTY, HOLD, CFU, CFB,
CFNR, CCBS and CLIR are often only
available in connection with DTMF.
Therefore select DTMF if the network provider
allows both dialling modes.
Metering pulses: Select the frequency used by
the network provider. In Germany 16 kHz is the
standard value.
Send "#": Here you select whether the # (hash)
attached to the telephone number as a sign for the
end of a dialled number has to be transmitted also
to the public exchange by the Analog/ISDN Con-
verter.
Activate this setting if the attached # is necessary
e.g. for special functions in an LCR router or for
the operation of a VoIP device.
Deactivate this setting if the attached # is only a
sign for the end of a dialling.
51