ECG KR 814 Bedienungsanleitung Seite 36

Blender
1. Insert carefully a sealing ring in the groove of the base of the blender. A
damaged or improperly inserted sealing ring may cause content leakage.
2. Fasten the blender container to the base of the blender.
3. Put the ingredients in the container of the blender.
4. Insert the fi lter cap in the lid and turn.
5. Turn the lid clockwise to secure it to the container.
6. Set the assembled blender in the base of the food processor and secure
it by turning.
7. Set speed or use the pulse mode.
8. When the appliance is running, do not move the container, the lid or the
fi lter cap.
9. The maximum capacity of the blender container is 1,5 liters.
To ensure longevity of the appliance, do not let it run continuously for more than 30 seconds and always let
the motor cool down for at least a minute after three cycles.
Juicer
• Use the juicer to produce juices from solid fruits and vegetables.
1. Set the drive shaft and the juicer container in the base.
2. Put the strainer in the inner bowl and secure it.
3. Place the inner bowl in the work bowl of the food processor.
4. Put the lid on the bowl and turn it to secure it in such a way that the
feed tube is above the handle.
5. Cut the foods in smaller pieces in order that they fi t comfortably into
the feed tube.
6. Switch the food processor on and using the pusher, push the pieces
down evenly. Never insert fi ngers in the feeding tube! Before you add
the next portion, fi rst process fully the previous one.
7. After adding the last piece, let the appliance run for another
20 seconds to get all the juice off the strainer.
8. Do not use the rotating strainer if it is damaged in any way.
To ensure longevity of the appliance, do not let it run continuously for
more than 3 minutes. Let it cool down for 30 seconds prior to using it
again.
Citrus fruit press
• Use the citrus fruit press to obtain juice from citrus fruit (e. g. oranges, lemons, limes
and grapefruits).
To ensure longevity of the appliance, do not let it run continuously for more than 3 minutes.
Let it cool down for 30 seconds prior to using it again.
EN
36
°
°
30°
90°