Replacing The Lamp; Closing The Door; Technical Data; Installation - AEG Electrolux SANTO 72398-6KA Benutzerinformation

14

Technical data

Replacing the lamp

1. Switch off the appliance.
2. Press on the rear hook and at the same
time slide the cover in the direction of
the arrow.
3. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the lamp cover).
4. Install the lamp cover by sliding it into
its original position.
5. Switch on the appliance.
6. Open the door. Make sure that the light
comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the ap-
pliance before installing the appliance.
Height
Width
Depth
1800 mm
600 mm
650 mm