Installation; Connection Cable; Before The Installation - JUNO JKSI808R5 Benutzerinformation

14
Problem
comes on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error

INSTALLATION

WARNING! Refer to Safety
chapters.

Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
Possible cause
There is an error in the hob
because a cookware boils
dry. Automatic Switch Off
and the overheating protec-
tion for the zones operate.
message that comes on. Make sure, you
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee
are in the guarantee booklet.
and work surfaces that align to the
standards.

Connection cable

• The hob is supplied with a connection
cable.
• To replace the damaged mains cable
use the following (or higher) mains cable
type: H05BB-F Tmax 90°C. Speak to
your local Service Centre.
Remedy
Deactivate the hob. Remove
the hot cookware. After ap-
proximately 30 seconds, acti-
vate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware
become sufficiently cool.
Check if your cookware is
compatible with the hob.
Refer to "Hints and tips"
chapter.