Technical Data; Installation; Electrical Connection - Küppersbusch IKEF3080-2Z3 Benutzerinformation

Problem
The temperature in the
refrigerator is too high.
The temperature in the
freezer is too high.
Upper or lower square is
shown in the tempera-
ture display.
dEMo appears on the
Display.

TECHNICAL DATA

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Possible cause
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
The door is not closed correctly.
An error has occurred in meas-
uring the temperature
The appliance is in demonstra-
tion mode (dEMo)
Height
Width
Depth
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Refer to "Closing the door".
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
Keep pressed approximately 10
sec. the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
1780 mm
560 mm
550 mm
18 h
230-240 V
50 Hz
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C

Electrical connection

Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
31
Solution