Parkside PZKS 1500 B2 Originalbetriebsanleitung Seite 34

Safety information
Repairs may only be carried out by
the manufacturer or an authorized
representative.
- Do not remove any cutting residues or
other parts of workpieces from the cutting
zone while the machine is running and
the saw unit is not at rest.
Instructions for proper and safe sawing:
a) Clamp the workpiece always at the saw
table firmly. Therefore please use the
supplied clamping device.
b) Before each cut, ensure that the machine
is stable.
c) If necessary attach the machine to
a workbench or the like. Fasten the
machine to the workbench.
d) Support long workpieces (e.g. with a
roller table) to prevent them sagging at
the end of a cut.
e) Make sure that the saw blade does not
touch the rotary table in any position by
pulling out the mains plug and rotating
the saw blade by hand in the 45° and
90° position. If necessary, readjust the
saw head.
WARNING! This electric tool generates an
electromagnetic field during operation. This
field can impair active or passive medical
implants under certain conditions. In order to
prevent the risk of serious or deadly injuries,
we recommend that persons with medical
implants consult with their physician and the
manufacturer of the medical implant prior to
operating the electric tool.
SAFETY INSTRUCTIONS FOR THE
HANDLING OF SAW BLADES
1 Only use insertion tools if you have
mastered their use.
2 Observe the maximum speed. The
maximum speed specified on the
insertion tool may not be exceeded.if
specified,observe the speed range
3 Observe the motor / saw blade direction
of rotation.
4 Do not use any insertion tools with
cracks. Sort out cracked insertion tools.
Repairs are not permitted.
5 Clean grease, oil and water off of the
clamping surfaces.
6 Do not use any loose reducing rings or
bushes for the reducing of holes on saw
blades.
7 Make sure that fixed reducer rings for
securing the insertion tool have the same
diameter and have at least 1/3 of the
cutting diameter.
8 Make sure that fixed reducer rings are
parallel to each other.
9 Handle insertion tool with caution.
They are ideally stored in the originally
package or special containers. Wear
protective gloves in order to improve grip
and to further reduce the risk of injury.
10 Prior to the use of insertion tools, make
sure that all protective devices are
properly fastened.
11 Prior to use, make sure that the insertion
tool meets the technical requirements of
this electric tool and is properly fastened.
12 Only use the supplied saw blade for
cutting wood, never for the processing of
metals.
Attention: Laser radiation
Do not stare into the beam
Class 2 laser product
laser specification according to
EN 60825-1:2014
: 650 nm P ≤ 1 mW
LASER
2
Protect yourself and you environment
from accidents using suitable
precautionary measures!
GB / IE / NI 29