ZANKER KDV10030FA Benutzerinformation Seite 21

• Adjust the level of the water softener according to
the water hardness.
• Activate or deactivate the acoustic signal indicating
the end of a programme.
• Activate or deactivate AirDry.
Before entering the user mode, make sure the
appliance is in the programme selection mode.
To enter the user mode:
Press and hold simultaneously
3 seconds.
The indicators:
As the appliance stores the saved settings, there is no
need to configure it before every cycle.
Adjusting the water softener
Make sure the appliance is in user mode.
The water hardness table
German degrees
(°dH)
47 -50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting
2) Do not use salt at this level.
Activating the acoustic signal at the end of a
programme
Make sure the appliance is in user mode.
1. Press .
The indicators:
still flashes.
and for at least
, , and start flashing.
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
and are off. The indicator
1. Press
The indicators
still flashes.
The indicator
flashes indicates the current water softener setting (e.g.
5 flashes + pause + 5 flashes... = level 5).
2. Press
of the button
by one. After reaching level 10, the count starts
from level 1.
3. Press on/off to confirm and save the setting.
mmol/l Clarke degrees
8.4 - 9.0
7.6 - 8.3
6.5 - 7.5
5.1 - 6.4
4.0 - 5.0
3.3 - 3.9
2.6 - 3.2
1.9 - 2.5
0.7 - 1.8
<0.7
The indicator
acoustic signal is active. If off = the acoustic signal is
disabled.
2. Press to change the setting.
3. Press on/off to confirm and save the setting.
.
and are off. The indicator
starts flashing. The number of
to change the setting. Each pressing
increases the level number
Water softener lev-
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
shows the current setting. If on = the
el
10
9
8
7
6
5 1)
4
3
2
1 2)
21