Starting The Engine; Connecting Consumers To The Generator; Switching Off The Engine - Scheppach 5906205901 Originalbetriebsanleitung

• Check the fuel level and top it up if necessary
Make sure that the generator has sufficient ventilation
•
Make sure that the ignition cable is secured to the spark plug
•
Inspect the immediate vicinity of the generator
•
Disconnect any electrical equipment which may already be connected to the generator
•
Mixture
1:40

8.1 Starting the engine

• Before starting , ensure that no applicance has been connected to the generator .
• Open the petrol cock (8) by turning it down
• Move the ON/OFF switch (5) to position "ON" with the key.
• Move the choke lever (4) to position IØI.
• Start the engine with the reversing starter (7) by pulling the handle forcefully. Return the re-
versing starter gently and slowly to the original position by hand. If the engine does not start,
pull the handle again.
Note: when the motor is started for the very first time. It will require a number of attempts to
start until the fuel has travelled from the tank to the motor.
• Push the choke lever (4) back again after the engine has started.
Important!
When starting with the reserve starter, the motor may
recoil suddenly as it starts up, resulting in hand injuries. Wear protective gloves when starting
the equipment.

8.2 Connecting consumers to the generator

• Checking the start switch oft he appliance is on off before connecting it tot he generator.
• Connect the appliance you want to use to the 230 V~ socket.
Important: This socket may be loaded continuously (S1) with 650W and temporarily (S2) for a
maximum of 2 minutes with 720W.
• The generator is suitable for 230 V~ a.c. appliances.
• Do not connect the generator to the household network as this may result in damage to the
generator itself or to other electrical appliances in your home.
Note: Some electrical appliances (power jigsaws, drills, etc.) may have a higher level of power
consumption when used in difficult conditions.

8.3 Switching off the engine

• Before you switch off the generator, allow it to run briefly with no consumers so that it can
"cool down"
• Move the ON/OFF switch (5) to position "OFF" with the key.
• Close the petrol cock
Important: The generator is equipped with an overload cut-out.
This shuts down the socket (6). You can reactivate
the socket (6) by pressing the overload cut-out (3).
Important! If this happens, reduce the electric power you are taking from the generator or
remove any defective connected appliances.
46 GB
Regular unleaded Petrol
1l
2l
3l
4l
2- stroke - oil
25 ml
50 ml
75 ml
100 ml