ZANKER PVX1556 Benutzerinformation Seite 16

Problem and alarm code
The appliance door is difficult to close.
Rattling/knocking sounds from inside the appli-
ance.
The appliance trips the circuit-beaker.
Refer to "Before first use", "Daily
use", or "Hints and tips" for other
possible causes.
Once you have checked the appliance, deactivate and
activate the appliance. If the problem occurs again,
contact an Authorised Service Centre.
The washing and drying results are not satisfactory
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or bluish lay-
ers on glasses and dishes.
There are stains and dry water drops
on glasses and dishes.
16
• The appliance is not levelled. Loosen or tighten the adjusta-
ble feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The tableware is not properly arranged in the baskets. Refer
to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneously all the
appliances in use. Check the socket amperage and the ca-
pacity of the meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Author-
ised Service Centre.
For alarm codes not described in the table, contact an
Authorised Service Centre.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and basket loading leaflet.
• Use more intensive washing programmes.
• Clean spray arm jets and filter. Refer to "Care and Cleaning".
• Tableware has been left for too long inside a closed appliance.
• There is no rinse aid or the dosage of rinse aid is not enough. Set the
rinse aid dispenser to a higher level.
• Plastic items may need to be towel dried.
• For the best drying performance activate the option XtraDry and set
AirDry.
• We recommend to always use rinse aid, even in combination with multi-
tablets.
• The release quantity of rinse aid is too much. Adjust the rinse aid level
to a lower level.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient. Adjust the rinse aid
level to a higher level.
• The quality of the rinse aid can be the cause.
Possible cause and solution