cessible from the outside, using only a soft
cloth and warm water.
Ensure that the ice container is thoroughly
dry before being refitted.
Important! Do not use detergents or
abrasive paste.
Cleaning the ventilation grille
The ventilation grille can be removed for
washing.
Make sure the door is open and then:
1. Loosen the upper edge of the grille by
pulling outward/downward.
2. Pull the grille straight out to completely
remove it.
3. Vacuum clean under the cabinet.
Defrosting of the freezer
The freezer compartment of this model, on
the other hand, is a "no frost" type. This
WHAT TO DO IF...
During operation of the appliance some
smaller but annoying trouble can often oc-
cur, which does not require calling a techni-
cian out. In the following chart information is
given about them to avoid unnecessary
charges on service.
Important! The operation of the appliance
goes with certain sounds (compressor and
Problem
The appliance is noisy.
A rattling noise.
Possible cause
The appliance is not supported
properly.
The cushion spacers located be-
tween the back of the cabinet
and the pipes come loose.
The ice being stirred to prevent it
from freezing together.
means that there is no buildup of frost
when it is in operation, neither on the inter-
nal walls nor on the foods.
The absence of frost is due to the continu-
ous circulation of cold air inside the compart-
ment, driven by an automatically controlled
fan.
Periods of non-operation
When the appliance is not in use for long pe-
riods, take the following precautions:
1. Switch of the ice machine
2. Turn off the water connection
3. Empty the ice container
4. Disconnect the appliance from electricity
supply
5. Remove all food
6. Clean the appliance and all accessories
7. Leave the door/doors open to prevent
unpleasant smells.
When the ice maker starts again, do not
use ice produced during the first day to en-
sure fresh taste.
Important! If the cabinet will be kept on,
ask somebody to check it once in a while to
prevent the food inside from spoiling in
case of a power failure.
circulating sound). This not means a
trouble, but a normal operation.
Important! The appliance operates
discontinuously, so the stopping of
compressor does not mean being no
current. That is why you must not touch the
electrical parts of the appliance before
breaking the circuit.
Check if the appliance stands sta-
ble (all feet and wheels should be
on the floor). Refer to "Levelling".
Put them back in place again.
No measure necessary, this
sound is normal.
As an alternative, refer to "To acti-
vate the night setting"
electrolux 11
Solution