Maintenance - JUNO JDL 4530 Montage- Und Gebrauchsanweisung

— The best performances are obtained with
short pipes (max. 4 m) and with few
curves.
Electric connection
Before completing any connection, make
sure the house voltage corresponds with
the voltage indicated on the label affixed
inside the hood.
The hood is supplied with a standard plug;
connect it to a correspondingly standard
socket.
In the case is intended to connect the
appliance permanently to the mains after
having removed the plug supplied, must be
fitted a two-pole switch conforming to
regulations with an opening distance
between contacts of not less than 3mm.
The manufacturers are not liable for any
problems caused by the user's failure to
observe the above instructions.
Fixing the hood
After having adjusted the hood for the version
required, it may be installed.
— This appliance is designed for fitting in a
cabinet or some other support.
— The opening to be made on the bottom of
the wall-hung cabinet must correspond
with the measurements shown in fig. 5.
To fix the hood proceed as follows:
a) Remove the metal filter and the frame.
b) Fit the hood into the opening.
c) Secure the unit to the cabinet by screwing
up screws through holes F (fig. 6).
d) Refit the frame (Fig. 4), then the metal
filter (Fig. 3).
Instructions
Hoods model JDL 4530 is fitted with 2
motors.
The power is adjusted by means of an
electronic sliding switch, plus an intensive
set located at the end of the switch run.
For the best performance, we recommend
using the low speeds in normal conditions
and the high speeds in particular cases of
strong odour and vapour concentration.
We recommend starting up the hood a few
minutes before cooking and keeping it
running until all the odours have been
eliminated.
The switching plate is fitted with two switches
one for continuous adjustment of the
ventilator (right switch) and one for
illuminating the work surface (left switch) .

Maintenance

Before performing any maintenance
operation, disconnect the hood from the
electricity.
Metal grease filter
The hood has a metal grease filter.
The metal grease filter lasts forever and
must be washed either by hand or in the
dishwasher (65°C) with suitable detergents.
The grease filters must be washed at least
once a month.
Attention! When washed in a dishwasher,
the metal grease filter may discolour.
Before refitting the filter ensure that it is
perfectly dry.
When cleaning the grease filter, we
recommend washing the frame that
surrounds the filter.
Carbon filter
It keeps the odours and smells and leave the
aspirated air cleaned from them.
The carbon filter should be replaced every 4
months under normal use.
The carbon filter cannot be washed nor
regenerated.
To dismount it proceed as follows:
a) Remove the metal filter (Fig. 3) and the
frame (Fig. 4).
b) Turn the central handle of the carbon
filter anticlockwise and extract it (Fig. 5,
E).
To fit the carbon filter proceed in reverse
order.
Attention
Failure to observe the rules for cleaning the
appliance and changing and cleaning the
filters may cause fires.
Therefore, we recommend observing these
instructions.
8