Bauknecht DF 5260 SG Bedienungsanleitung Seite 6

Note: the elements marked with the symbol "(*)" are optional accessories supplied only with some models or elements to purchase,
not supplied.
Extraction version installation (A): Fumes are extracted and expelled to the outside through an exhaust duct fixed to the upper circular
flange A1 (bayonet coupling + screw fastening) or rear rectangular flange A2 (*) (fastened using 2 screws). Select the desired exhaust
direction, remove the corresponding pre-scored metal panel and fit the duct connector which matches the shape of the opening.
Filter version installation (F): If fumes and steam cannot be discharged to the outside, the hood can be used in filter version by
fitting a carbon filter/s (*); fumes and steam are recycled through the front grille located above the control panel (do not remove the
pre-scored metal panels!).
Check the position of the extraction/filter selector (inside the hood) G.
Wall fixing - Place the hood against the wall (or use the template H, if provided) and mark the holes
(3 or 4 Ø 8 mm holes) with a pencil, drill, insert the wall plugs J in the holes and 2 screws K in the top holes, remove the grille and
hook the hood on the 2 screws, then insert the third (and fourth) screw/s L from inside and tighten all of them.
Fixing to wall unit - Position the hood (or use the template H, if provided) and, using a pencil, mark the 4 Ø 6 mm through holes to
be made on the bottom of the wall unit.
Fix the hood with 4 screws M from inside the wall unit.
Control panel
Light: move the switch to the right or press the next button to switch on.
Extraction speed: Move the switch to the right or press the next button to increase extraction speed.
Grease filter - can be one of the following types:
Paper filter: to be replaced once a month or, if the top part is coloured, when the colour shows through the holes in the grille.
Metal filter: to be washed once a month by hand or in a dishwasher with quick wash cycle at low temperature.
To access the grease filters open the grille by means of the releases E1and free it from the retainers R1.
The carbon filter (*) must be changed once a month.
Warning! The metal filter may become opaque over time; this does not affect its filtering capacity.
Replacing lamp/s - Remove the grille and the lamp to be replaced (incandescent lamp 40 W max. E14). Refit the grille.
Cleaning the hood
Warning! Failure to remove oil/grease (at least once a month) could result in fire.
Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol.
5019 418 33094
D GB F NL E
GB
P GR
I PL CZ
BG RO
SK H RUS
LI24VA