TERMA SOA Gebrauchsanweisung Seite 49

• If you want to turn the TIMER off, press
the button several times or simply turn
the heating element off and on,
• TIMER LED diodes will turn off one by
one, to display the correct, remaining
drying time.
Modification of radiator heating
power level
The default power level setting of the heat-
ing element is 100% of its nominal power.
The user can modify this level by following
these steps:
1. Disconnect the device from the electric-
ity supply (i.e. unplug the device).
2. Press and hold the on/off button while
reconnecting the heater to the electrici-
ty supply.
3. Release the button .
4. One of 5 TIMER diodes will start flash-
ing. Select the required power level by
pressing the button until the corre-
sponding diode starts flashing. Power
level values for each diode are shown
in the table below:
Pulsating diode
number
1
2
3
4
5
5. Wait for 10 seconds or press the TIMER
button in order to confirm your cho-
sen value.
EN
Power output
level
30%
40%
60%
80%
100%
49