Troubleshooting And Fault Elimination; Error Messages - Lenze EPM-H520 Betriebsanleitung

Show/Hide Bookmarks
6
6.1
L

Troubleshooting and fault elimination

Troubleshooting and fault elimination

Error messages

Call up the status messages of the keypad to see the last error message.
Display ( ERROR ) Error
No error
NO ERROR
Faulty data
PR ERROR
exchange
Communication
COM BROK
interrupted
Communication Communication
ASIC ko1 ASI ko1
with system ith
ASIC ko2
bus (CAN) bus (CAN)
interrupted interrupted
ASIC ko3
ASIC ko4
RESET
SDOERR 6
SDOERR 5
SDOERR 3
Cause
-
Faulty connection between
keypad and PC
Serial data cable between
keypad and PC defective or
not properly connected
• •
Faulty system bus wiring Faulty system bus wiring y y
t (e.g. polarity reversal) ( l it
• •
Faulty parameter setting Faulty parameter setting
for interface (baud rate, for interface (baud rate,
address, identifier) address, identifier)
EDBEPM-H520 DE/EN/FR 4.0
(% 77)
Remedy
-
•
Check connection
•
Check cable
•
Check Sub D plug connection
•
Replace serial data cable
• •
g Check wiring ( * 66 ) Check wiring ( * 66 ) g (
l) •
Check parameter setting ( * See
"HMI Designer - Getting Started" "HMI Designer Getting Started"
Manual ) Manual )
)
91