Herunterladen Inhalt Inhalt Diese Seite drucken

Remove The Plug From De Socket; Cleaning; Light Replacement; Solving Problems - Hotpoint Ariston MWA 122/HA Bedienungsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 42
Remove the plug from the socket
Make sure that the oven is unplugged before cleaning
the oven.
Don't use abrasive cleaning products.

Cleaning

Outside
1. Clean the outside surface with neutral detergent,
lukewarm water and dry it with a damp cloth.
2. Avoid water from entering the oven ventilation holes.
Inside
1. Clean the oven walls with a damp cloth after each
use.
2. Avoid water from entering the ventilation holes in the
oven's interior.
3. If some time has passed by since the last cleaning
and the oven's interior is dirty, place a glass of water
on the tray and switch on the oven for 4 minutes on the
highest setting. Moisture will form on the oven walls,
which will be easily cleaned.
4. The tray can be washed with regular dish washing
detergent or in the dishwasher.
Door, door seal, and oven front
1. These parts should always be clean, especially the
contact surface between the door and the oven front, to
prevent microwave leakage.
2. Use neutral detergent, lukewarm water and dry the
surface with a soft cloth.

Light Replacement

The light bulb may only be replaced by the Technical
Support Service.

Solving Problems

Repairs or interventions carried out by an unqualified
serviceman can cause dangerous situations.
Every and any kind of repair or intervention should
be done by the manufacturer, authorized agents or
qualified technicians.
If you detect any abnormalities in the oven, check the
following before you contact T.A.S:
1. Check if the outlet into which the oven is plugged
has power. To do so, plug another appliance into the
same outlet and check if it works.
2 If the oven lamp switches on, but the food does not
heat up, check if the door is well closed (if the door is
not properly closed, no microwaves will be produced).

Cord Replacement

If the cord is damaged, it should be replaced by the
manufacturer, authorized agents or qualified
technicians in order to avoid any dangerous situation
and also because special tools are required.
27

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis