System Connections; Aerial Connection - Sharp CD-XP300H Bedienungsanleitung

System connections

CD-XP300H
ENGLISH
AM loop aerial
Right speaker
„ Removing the transport screw
Before turning the power on, be sure to remove the transport screw on
the back of the unit using a flat head screwdriver or a coin.
Note:
This screw is required when transporting the unit again. Please keep it (see page 27).
E-7
FM aerial
Transport screw
Left speaker
Wall socket
(AC 230 V, 50 Hz)

„ Aerial connection

Supplied FM aerial:
Connect the FM aerial wire to the FM 75
OHMS socket and position the FM aerial wire
in the direction where the strongest signal can
be received.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM LOOP
socket. Position the AM loop aerial for opti-
mum reception. Place the AM loop aerial on a
shelf, etc., or attach it to a stand or a wall with
screws (not supplied).
Note:
Placing the aerial on the stereo system or near the AC power lead may cause noise
pickup. Place the aerial away from the stereo system for better reception.
Installing the AM loop aerial:
< Assembling >
External FM aerial:
Use an external FM aerial if you require better reception. Consult your dealer.
01/12/11 CD-XP300H(H)E1.fm
< Attaching to the wall >
Wall Screws (not supplied)
External FM aerial