Storing Your Own Sound Adjustments - JVC KD-LX555R Bedienungsanleitung

Storing your own sound
adjustments
You can adjust the sound modes to your preference
and store your own adjustments in memory
(USER 1, USER 2 and USER 3).
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press BAND MODE (M).
BAND
MODE
M
2
Press EQ (equalizer) while "MODE" is
still on the display.
EQ The last selected sound mode is
1 7
called up.
3
Select the sound mode you want to
adjust.
4
Select sound elements to adjust.
SEL
S
LOW FREQ.* = LOW WIDTH = LOW LEVEL =
MID FREQ.* = MID WIDTH = MID LEVEL =
HIGH FREQ.* = HIGH LEVEL =
(back to the beginning)
FREQ. (LOW, MID, HIGH):
Select the center frequency to adjust.
WIDTH (LOW, MID):
Select the band width level (Q).
LEVEL (LOW, MID, HIGH):
Adjust the enhancement level.
30
"MODE" appears on the
display.
Ex.: If you have selected "JAZZ"
Each time you press the
button, the sound elements
change as follows:
* By pressing
can directly move as follows:
LOW FREQ.
5
Adjust the selected sound element.
• Refer to the table below
6
Repeat steps 4 and 5 to adjust the
other sound elements.
7
Select one of the user sound modes
(USER 1, USER 2, USER 3).
EQ
1
7
8
Press EQ to store the adjustments.
"MEMORY" appears for a while.
EQ
1 7
To reset to the factory settings
Repeat the same procedure and reassign the
preset values listed in the table on page 49.
Indication
LOW
50 Hz
FREQ.
80 Hz
120 Hz
1 (min.)
WIDTH
|
4 (max.)
–06 (min.) –06 (min.)
|
LEVEL
+06 (max.) +06 (max.) +06 (max.)
¢ or 4
, you
MID FREQ.
HIGH FREQ.
for adjusting the selected
sound element.
Preset values
MID HIGH
700 Hz 8 kHz
1 kHz 12 kHz
2 kHz
1 (min.)
|
2 (max.)
–06 (min.)
| |