How To Replace The Battery - JVC KV-M70 Bedienungsanleitung

Before using the wireless remote controller

How to replace the battery

When it becomes necessary to bring the wireless remote controller close to the remote sensor
for it to work, the battery is running low. At this point, the battery should be replaced. (Battery life
is about 1 year with normal use.)
(back side)
b
a
Lithium coin
battery
(product number:
CR2025)
(back side)
• A battery is already installed in the wireless remote con-
troller. Remove the insulation film before using.
Remove the battery case.
Push in the direction indicated by the arrow with your right
hand thumbnail.
Remove the battery case.
Replace the battery.
Put the battery in the case with the
Return the battery case.
Re-insert the battery case pushing until you hear a clicking
sound.
WARNING:
• Store the batteries in a place which children cannot reach.
* If a child somehow ingests the battery, immediately consult a doctor.
• Do not recharge, short, disassemble or heat the batteries or put
them in a flame.
Doing any of these things may cause the batteries to give off heat, crack or
start a fire.
• Do not mix the batteries with other metals.
Doing this may cause the batteries to give off heat, crack or start a fire.
• When throwing away or saving the batteries, wrap in tape and
insulate.
If this is not done, it may cause the batteries to give off heat, crack or start
a fire.
• Do not poke the batteries with a metal pin set or similar device.
Doing this may cause the batteries to give off heat, crack or start a fire.
9
side facing upwards.