Worx WX639 Übersetzung Der Originalbetriebsanleitung Seite 10

SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Warning
Double insulation
Wear eye protection
Wear ear protection
Wear dust mask
Waste electrical products
10
should not be disposed of with
household waste. Please recycle
where facilities exist. Check with
your Local Authority or retailer
for recycling advice
Finishing sander
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for dry sanding of
wood, plastic, filler and coated surfaces.
ASSEmbLy
1. FIT ThE SANDING PAPER
SANDING PAPER wITh hOOK & LOOP
SySTEm (See Fig. A)
The sanding papers are placed directly onto
the base plate. The hole pattern in the sanding
plate and sanding paper must match.
Before placing on the sanding paper, free the
base plate from dust/debris by lightly tapping
against it.
2. REmOVE ThE SANDING PAPER
SANDING PAPER wITh hOOK & LOOP
SySTEm
Simply remove the sanding paper directly.
3. PAPER PUNch
If using sanding paper without dust holes,
use the paper punch to perforate the holes to
ensure correct dust extraction. Position the
punch (10) over the base plate with the punch
sides on the edges of the base plate. Press the
punch into the base plate to punch holes into
the sanding paper. Then remove the punch
and check all the holes have been formed
correctly.
OPERATION
1. SwITchING ON/OFF (See Fig. b)
Depress "I" on the on/off switch to start the
machine.
Depress "0" on the on/off switch to stop it.
2. VARIAbLE SPEED cONTROL
(See Fig. c)
With the variable speed control (9), the
required speed can be selected (also while
running).
The required speed is dependent on the
material and is to be determined by a practical
trial.
After longer periods of working at low speed,
EN