DANGER of electric shock
Do not operate the device if it or the cable shows visible signs
of damage or if the device has been dropped.
Only connect the mains plug to a properly installed socket,
which is easily accessible and supplies voltage matching the
rating plate. The socket must still be easily accessible after
connection.
Ensure that the cable cannot be damaged by sharp edges or
●
●
hot surfaces. Do not wrap the cable around the device (cable
break danger!).
Make sure the cable is not trapped or crushed.
●
●
Always pull on the plug and never on the cable when remov
●
●
ing the device.
Remove the mains plug from the socket, ...
●
●
... after each use,
... if a fault occurs,
... when you are not using the device,
... before cleaning the device and
... during thunderstorms.
Never attempt to remove dust or foreign bodies from inside
●
●
the device using pointed objects (e.g. a tail comb).
To avoid any risk, do not make any changes to the device or
●
●
accessories. Do not replace the cable yourself either. Repairs
must only be carried out by a specialised company.
DANGER – Fire hazard
Never leave the device unattended while plugged in.
Never cover the device or place it on soft objects
●
●
(e.g. bath towels).
Ensure that the air inlet and air outlet are always free. Keep the
●
●
air inlet free from long hair or objects that could get sucked
into it.
20
This device has an overheating protection system.
●
●
In the event of overheating, e.g. if the air inlet or air outlet is
covered, the device switches itself off automatically. If this oc
curs, set the on/off switch to 0 (off), pull out the plug from the
mains socket, and allow the device to cool adequately. Before
switching it back on, ensure that there are no hairs or foreign
bodies blocking the air inlet.
Do not switch on the device at the same time as another
●
●
device with high power consumption plugged in to the same
multiple socket.
Do not use an extension cable.
●
●
DANGER of burns
Do not direct the hot air flow at eyes, hands or other parts of
the body that are sensitive to heat.
Do not touch the hot surface of the device.
●
●
Allow the device to cool down completely before you clean it
●
●
or put it away.
Allow the styling brushes to cool before removing them from
●
●
the appliance.
WARNING! Risk of injury
Place the cable in such a way that no one trips over it
or steps on it!
CAUTION! Risk of material damage
Use the original accessories only.
Never place the device on hot surfaces (e.g. hob plates)
● ●
or near heat sources or open fire.
Do not use any harsh or abrasive cleaning agents.
● ●
Do not expose the device to temperatures below –10 °C or
●
●
above + 40 °C.
21