Herunterladen Inhalt Inhalt Diese Seite drucken
Eton RES 10 A Einbauanleitung

Eton RES 10 A Einbauanleitung

10" ersatzradmulden aktiv & passiv subwoofer

Werbung

10" ERSATZRADMULDEN
AKTIV & PASSIV SUBWOOFER
ACTIVE & PASSIVE SUBWOOFER
RES 10 A
RES 10 A
RES 10 P
RES 10 P
EINBAU-ANLEITUNG
INSTRUCTION MANUAL
10" SPARE WHEEL

Werbung

Inhaltsverzeichnis
loading

Inhaltszusammenfassung für Eton RES 10 A

  • Seite 1 10" ERSATZRADMULDEN AKTIV & PASSIV SUBWOOFER 10" SPARE WHEEL ACTIVE & PASSIVE SUBWOOFER RES 10 A RES 10 A RES 10 P RES 10 P EINBAU-ANLEITUNG INSTRUCTION MANUAL...
  • Seite 2 Wahl dieses ausgezeichneten Produktes. you on the selection of this excellent product. Der ETON Subwoofer garantiert hervorragen- The ETON subwoofer is a guarantee for out- de Leistungen. Die elektrischen, mechani- standing performance. The electrical, mechani- schen und klanglichen Eigenschaften bleiben cal and tonal characteristics will be maintained über die gesamte Lebensdauer des Produk-...
  • Seite 3: Sicherheitshinweise

    ETON übernimmt keine Verantwortung für ETON accepts no liability for hearing Gehörschäden, körperliche Schäden oder loss, bodily injury or property damage Sachschäden, die aus dem Gebrauch oder as a result of use or misuse of this Missbrauch seiner Produkte entstehen.
  • Seite 4: Verpackung Und Inhalt

    Verpackung und Inhalt Table of contents Der Subwoofer ist in einem dafür konstruierten The subwoofer is packed into an especially schützenden Karton verpackt. Beschädigen Sie constructed protecting carton. Do not dama- die Verpackung nicht und bewahren Sie diese ge the packing and store it for future use in für die spätere Verwendung im Schadensfalle the case of possible damage.
  • Seite 5: Vorsichtsmaßregeln

    Vorsichtsmaßregeln Precations – Read first Achtung! Entfernen Sie vor dem Einbau den Caution! Before installation, disconnect the negativen Batteriepol, um Schäden am Gerät, battery negative (-) terminal to prevent da- Feuer bzw. mögliche Verletzungen zu vermei- mage to the unit, fire and/or possible injury. den.
  • Seite 6: Vor Dem Einbau

    Vor dem Einbau Before Installation Dieser Abschnitt konzentriert sich auf Erwä- This section focuses on some of the vehicle gungen hinsichtlich des Einbaus Ihres neuen considerations for installing your new sub- Subwoofers im Fahrzeug. Vorausplanung woofer. Pre-planning your system layout and Ihres Systemlayouts und der besten Verkabe- best wiring routes will save installation time.
  • Seite 7 Vor dem Einbau Before Installation 7. Vermeiden Sie es, Kabel über scharfe 7. Avoid running wires over or through sharp Kanten zu verlegen. Verwenden Sie Gummi- edges. Use rubber or plastic grommets to oder Plastikringe, um Kabel zu schützen, die protect any wires routed through metal, durch Metall verlegt werden (besonders die especially the firewall.
  • Seite 8: Einbau Und Verkabelung

    Einbau und Verkabelung Installation and wiring Anschlussdiagramm (High-Level Eingang) Wiring diagramm (High-Level Input) red/rot Fuse/Sicherung black/schwarz CHASSIS GROUND/ +12 V Battery / CHASSIS GROUND/ MASSE DER KAROSSERIE +12 V Batterie MASSE DER KAROSSERIE Hi-Level-In white/weiß grey/grau white/weiß grey/grau white-black/weiß-schwarz grey-black/grau-schwarz Bei Anschluss über den High-Level Eingang, With control via the High-Level Inputs, first the sollte zuerst der Adapterkabelsatz mit dem...
  • Seite 9 Einbau und Verkabelung Installation and wiring Anschlussdiagramm (Cinch / RCA Eingang) Wiring diagramm (Low-Level In / RCA Input) red/rot Fuse/Sicherung blue/blau black/schwarz CHASSIS GROUND/ +12 V Battery / CHASSIS GROUND/ REMOTE TURN ON / MASSE DER KAROSSERIE +12 V Batterie MASSE DER KAROSSERIE EINSCHALTPLUS Zum Anschluss des RES 10 über die Cinch...
  • Seite 10: Kabelfernbedienung

    Einbau und Verkabelung Installation and wiring Sichern Sie den Subwoofer mit der mitgeliefer- Securely mount the subwoofer to chass is ten Montageschraube & ggf. Halterings an der with the provided bolt. After the connection,- bestehenden Ersatzradhalterung Ihres Fahr- place in the spare wheel active subwoofer to zeuges.
  • Seite 11: Technische Daten / Specifications

    1 V – 9 V Source Voltage 14.4 V (10 V ~ 16 V) Abmessungen (BxH) 575 mm x 15 mm Weight in kg ~ 17,0 kg Pegelfernbedienung Ja / Kabel ETON Deutschland Electro Acoustic GmbH Pfaffenweg 21 89231 Neu-Ulm Germany www.etongmbh.com...
  • Seite 12 Notizen Notes...
  • Seite 13 Notizen Notes...
  • Seite 14 CE-Konformitätszertifikat Certificate of Conformity...
  • Seite 15 CE-Konformitätszertifikat Certificate of Conformity...
  • Seite 16 ETON behält sich das Recht vor, die beschriebenen Produkte ohne jegliche Vorankündigung zu verändern oder zu verbessern. Alle Rechte sind vorbehalten. Die auch teilweise Vervielfältigung des vorliegenden Handbuchs ist untersagt. ETON reserves the rigth to make modifications or improvements to the products illustrated without notice thereof. All rights belong to the respective owners.

Diese Anleitung auch für:

Res 10 p

Inhaltsverzeichnis