Operation; Specification - Blaupunkt IPC-S1 Bedienungsanleitung

5. Loosen the knob, then screw the IP Camera onto the stand by
turning the collar.
6. Adjust camera angle then tighten the knob to fix camera into
place.
7. Connect Ethernet and/or AC adaptor when the camera
installation is complete.

Operation

Wifi Setting
There are 2 ways to setup the IP Camera's Wifi connection:
I. Access the IP Camera's Wifi page on Blaupunkt Home
Connect server to setup Wifi.
II. Use the WPS button to pair with your router. Press and hold
the WPS button for 2 seconds and release when the Blue
Network LED flashes. The Red Status LED will flash for 2-3
seconds to indicate the IP Camera is entering WPS mode. Use
your router to enter WPS mode and pair with the IP Camera. If
WPS pairing is successful, the Red Status LED will flash 3
times to indicate.
After finishing Wifi setting, unplug AC power to power down the IP
Camera, disconnect the Ethernet cable and repower on the IP
Camera again to use ONLY Wifi connection.
Live Video Stream
After learning into the Control Panel, the IP Camera can be
accessed via the Blaupunkt Home Connect server to provide live
video streaming service. Please refer to your Home Connect
Server instruction manual for detail.
Alarm Video Capture and Upload
The IP Camera serves as part of the alarm system after learning
into Control Panel. Whenever an alarm is activated by another
device in the alarm system, the Control Panel will notify the IP
Camera to record a video clip and upload to Blaupunkt Home
Connect server for user to check the alarm event.
The alarm video clip is composed of "pre-alarm" and "post-alarm"
video to provide complete video coverage of the alarm event. For
example, by factory default, the clip includes 10 seconds of
pre-alarm video before the event trigger instant and 20 seconds of
post alarm video after alarm activation. The duration of video
length can be adjusted on Blaupunkt Home Connect server to
maximum total of 40 seconds.
Privacy Mode
The IP Camera live streaming and video recording function can be
disabled by entering privacy mode if required. To enter or exit
privacy mode, press and hold the learning/privacy button for 2
seconds and release when the Status Red LED flashes twice.
When the IP Camera is under privacy mode, the Red Status LED
will stay on to indicate video streaming /recording is prohibited.
LED Indicator
On
Power LED
(Green)
Off
Flashes
2-3 seconds
3 Flashes
Status LED (Red)
2 Flashes
On
Off
Camera power on
Camera power off
for WPS protocol
activated
WPS pairing
successful
Camera enters or
exits privacy mode
Camera under
privacy mode
Normal Operation
On
Network LED
Off
(Blue)
Flash
Video Storage and Micro SD Card
The IP Camera has a Micro SD Card slot for optional local video
storage. (NO Micro SD Card is provided by factory) If you have
inserted a Micro SD Card into IP Camera, all videos recorded will
be stored in the card. When the SD Card is full, the IP Camera will
delete the oldest clip automatically if a new video is captured.
Power Supply
The IP Camera uses an AC/DC 5V 2A power adaptor as power
supply. Please only used the adaptor supplied by factory to
ensure reliability.

Specification

Environmental Condition
-10°C to 40°C, relative humidity 85% non-condensing.
Radio
2.4 GHz (Wifi)
Ethernet/WiFI
connected
Network
disconnected
Camera streaming
or recording video