Declaration Of Conformity; Battery Charging; Starting Operation - Bosch Professional GSC 10,8 V-LI Originalbetriebsanleitung

OBJ_BUCH-840-002.book Page 16 Thursday, December 11, 2008 4:11 PM
16 | English
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may
significantly reduce the exposure level over the
total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 08.12.2008
Assembly

Battery Charging

Use only the battery chargers listed on the
graphics page. Only these battery chargers
are matched to the lithium ion battery used
in your machine.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, com-
pletely charge the battery in the battery charger
before using your power tool for the first time.
1 609 929 S25 | (11.12.08)
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A long
battery service life is achieved in this manner.
Battery Charge-control Indication
The three green LEDs of the battery charge-con-
trol indicator 4 indicate the charge condition of
the battery 2. For safety reasons, it is only pos-
sible to check the status of the charge condition
when the machine is at a standstill.
To indicate the charge condition, press and hold
button 3 of the switched off machine.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
Removing the Battery
To remove the battery 2, press the unlocking
buttons 1 and pull the battery out of the
machine to the rear. Do not exert any force.
Operation

Starting Operation

Inserting the Battery
Use only original Bosch lithium ion batter-
ies with the voltage listed on the nameplate
of your power tool. Using other batteries can
lead to injuries and pose a fire hazard.
Note: Use of batteries not suitable for the
machine can lead to malfunctions of or cause
damage to the power tool.
Insert the charged battery 2 into the handle until
it can be felt to engage and faces flush against
the handle.
Capacity
≥2/3
≥1/3
<1/3
Reserve
Bosch Power Tools