Maintenance And Cleaning - indexa CO-Alarm CO90 Bedienungsanleitung Und Sicherheitshinweise

Function checks
Test the alarm once a month to ensure it is functioning
correctly.
To do this, keep the TEST button pressed for 4 seconds.
This activates the function test. The three LED light
indicators are activated alternately during the
function test. Three dashes appear on the display. The
signal horn sounds for 2 seconds at the end of the
function test.
If the carbon monoxide alarm is functioning properly,
the green indicator lights up again permanently.
The function test should be carried out regularly,
at least once a month
Exceptions:
!
A function test cannot be carried out during an
alarm.
!
If there is a CO concentration sufficient to trigger an
alarm - but an alarm has not been triggered yet -
the current CO concentration is displayed for 15
seconds when the TEST button is pressed. In this
case, a function test is not started.
False alarm
To fulfil its purpose, the carbon monoxide alarm is set
so that it is very sensitive. The system's sensor can
therefore also respond to other gaseous media. The
use of aerosols (propellants in sprays, etc.) and high
tobacco smoke concentrations can also trigger an
alarm. The device can also react to brief emissions of
exhaust gas, for example, when the equipment starts.

Maintenance and cleaning

!
Regularly clean the housing of the carbon monoxide
alarm with a duster or slightly damp cloth. Remove
as much of the dust deposits as possible from the slit
openings in the housing. Never use household
!
cleaners with ammonia (spirits of ammonia) or
other chemicals, such as cleaning agents or
solvents.
The CO alarm must never be sprayed with water!
!
The carbon monoxide alarm must not be painted or
coated.
!
Regularly check the functionality of the device (see
the chapter on function tests).
At the end of the alarm's service life
Under normal use, the alarm has a service life of up to
7 years. Replace the carbon monoxide alarm 7
years after the date of purchase or if the fault
warning signal is emitted.
Important
!
Any gas installation and any shut-off device must
fulfil the regulations that apply in the country where
the alarm is installed.
!
The CO alarm must be installed properly. Please
work as specified in the operating instructions.
!
Make absolutely sure that the CO alarm is installed
at the correct height.
!
We reserve the right to make improvements to the
construction and design.
Disposal
Packaging material, used batteries or electrical
products must not be disposed of as household
waste. Use your recycling system. Details are
available from your local authority.
Guarantee
We guarantee this device for 2 years from the date of
purchase.
The guarantee applies only to material and
manufacturing defects. Further claims or other claims,