5 System Installation; 6 Power Cord Connection; 7 Water Supply Line Connection; 8 Air Supply Line Connection - DENTSPLY Cavitron Prophy-Jet Gebrauchsanweisung

7.5 System Installation

• The Cavitron Prophy-Jet
®
System is designed to rest on a level surface. Be sure
unit is stable and resting on four feet.
• The Cavitron Prophy-Jet
®
System should not be positioned such that access to the
power input and AC power cord are limited.
• Placing unit in direct sunlight may discolor plastic
housing.
• The system has been equipped with a Cavitron
Wireless Foot Pedal which was factory synchronized
to operate with the system's base unit. If your office
has more than one Cavitron System with Tap-On
Technology, it is recommended that you mark the
Tap-On TM Foot Pedal and base unit for easy reference as
to which Tap-On Foot Pedal operates with which base
TM
unit. Should resynchronization be necessary, follow the
instructions in section 7.10.

7.6 Power Cord Connection

• Verify the Main Power ON/OFF switch, located at the
center front underside of the System, is set to the OFF
(O) position before proceeding.
• Insert the AC power cord into the power input on the
back of the System.
• Insert the pronged plug into an AC wall outlet.

7.7 Water Supply Line Connection

• Grasp the Water Supply Line (blue hose) by the end
opposite the quick-disconnect and insert it into the water
inlet connector until fully seated.
Air Polishing Prophylaxis
®
Air Polishing Prophylaxis
®
Tap-On
®
TM
• Connect the quick-disconnect to the dental office water
supply or a Cavitron DualSelect Dispensing System.
• Inspect all connections to make certain there are no
leaks.
TM
• To remove the water line from the Cavitron
Air Polishing Prophylaxis System, turn off the dental
office water supply. Disconnect the water supply line
from the dental office water supply. If a quick-disconnect
connector is attached to the end of the hose, relieve the
water pressure by pressing the tip of the connector in
an appropriate container and allow water to drain. To
remove the hose from the system, push on the outer ring
of the system's water inlet and gently pull out the water
line.

7.8 Air Supply Line Connection

• Grasp the Air Supply Line (black hose) by the end
opposite the quick-disconnect and insert it into the air
inlet connector until fully seated.
• Connect the quick-disconnect to the dental office air
supply or a Cavitron DualSelect Dispensing System.
• Inspect all connections to make certain there are no
leaks.
• A filter mounting bracket is included for hanging the air
filter. Mount the bracket to a suitable vertical surface
and slide the filter onto the bracket. The clear bowl
should hang downward allowing for moisture separation
and drainage of water from the air filter. See Section 10
System Care for replacement instructions.
10
Prophy-Jet
® ®
Press ring to release
water supply tube.