Clatronic KA 3642 Bedienungsanleitung Seite 33

8. Press the PROG button twice. "TIMER" will appear above
the time in the display.
9. Set start time:
• Set hours:
Press the HOUR button.
• Set minutes:
Press the MIN button.
• Leaving the setting mode:
Wait ca. 15 seconds after the last push of a button.
"TIMER" in the display goes out.
10. Press the ON / OFF button twice to start the TIMER
operation. The pilot lamp AUTO lights.
NOTE:
• The appliance swiches on automatically at the preset
time. The pilot lamp RUN lights.
• Press the ON / OFF button once to deactivate TIMER
operation.
• If you would like to start the brewing process sooner,
press the ON / OFF button twice. The pilot lamp RUN
lights.
The Coffee Is Ready
NOTE:
The brewing process lasts approximately 10 minutes.
• When no more coffee is flowing through the filter you can
remove the pot.
• Turn the device off.
WARNING:
• Before cleaning, always remove the mains plug and wait until the
device has cooled down.
• Do not immerse the device in water. Otherwise this might result in
an electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The exterior of the device should be cleaned as necessary
with a slightly damp cloth – without any additives.
• Remove spilled coffee grounds with a paper towel from
the inner casing. Afterwards wipe with a damp cloth.
• The coffee pot and the filter pad should be cleaned by
rinsing in warm water. Use a soft brush if necessary.
• Would you like to keep the remaining coffee warm? Leave
the appliance turned on until the end of the keep-warm
period. If you wish to keep the coffee warm even after the
keep-warm period has finished, pour the remaining coffee
into a thermal flask.
NOTE:
The filter holder can be removed from the machine by its
handle.
This makes it easier to dispose of the old coffee filter, for
example.
WARNING:
If you want to make another pot of coffee immediately,
switch off the device first. Let it cool down with the water
tank open in order to avoid hot water splashing when
refilling with water.
De-scaling is necessary when the brewing time increases
substantially.
• Use only commercially available citrus acidbased de-scaler.
• Follow the recommended instructions for use.
WARNING:
• Afterwards you should boil fresh water in the pot three or
four times in order to rinse out residues of the descaling
agent.
• Do not use any coffee powder!
• Do not use this water for consumption.
Cleaning
• Clean the appliance as described and let it dry completely.
• For longer periods of non-use we recommend storing the
appliance in its original packaging.
• Always store the appliance in a well-ventilated and dry
place out of reach of children.
De-scaling
Storage
33