Operating The Pierenstim Parese; Switching On The Device; Program Selection - schwa-medico PierenStim Parese Gebrauchsanweisung

Output current at a load
of 1 kΩ real
Impulse width
Impulse form
Current take-up
Voltage supply
Dimensions
Weight

Operating the PierenStim Parese

Switching on the device

The PierenStim Parese is ideally operated using the main circuit adapter (SNT
5-2400). Connect the included adapter SNT 5-2400 to the socket (no. 6) on the
PierenStim Parese and the plug on the mains adapter into the mains power socket.
If mains power operation is not possible, insert the included batteries into the
device (please refer to the section "Replacing The Batteries").
Switch on the PierenStim Parese with the
then with the program number which was operational when the device was last
switched off.

Program selection

Press the key to change to the next program. Once the last program (P8) is
attained, the device jumps again to program 1 (P1). If the editing function is in use
(free parameters settings for user programs U1 to U6), they appear after program
8 (P8).
60 mA, stepless regulation
10 ms to 2 sec.
Time shifted direct current impulse
alternating polarity or monophasic impulse
approx. 60 mA (without load)
4 x 1.5 V batteries (Alkaline LR6 AA)
or mains circuit adapter 5 V / 2400 mA
L x B x H 15.0 x 10.0 x 5.5 cm
approx. 380 g
key. The device starts first with P1,
English
29