Important Recommendations - LENCO L-90 Benutzerhandbuch

3. MAINTENANCE
TO REPLACE THE STYLUS (FIG A):
- Secure the tone arm in place using the tone arm lock.
- Pull the orange stylus unit forward in the directoin of the
arrow and remove it.
- Put in the new stylus following the reverse procedure.
TO DISASSEMBLE THE CARTRIDGE (FIG B):
- Secure the tone arm in place using the tone arm lock
- Remove the stylus (see section above).
- Release the screws, nuts and washer and then the headshell
and cartridge can be disassembled.
- Disconnect the four link wires at the level of the pick up head.
TO INSTALL A NEW CARTRIDGE
- Connect the four colored wires as shown in figure B.
- Push the cartridge up into the headshell.
- Reinstall the stylus.

IMPORTANT RECOMMENDATIONS

We advise you to clean your records using an impregnated rag with an antistatic product for maximum
enjoyment of your records and also to make them last.
We would also point out that for the same reason your stylus should be replaced periodically
(approximately every 250 hours).
Dust the stylus from time to time using a very soft brush dipped in alcohol (brushing from the back to
the front of the cartridge).
Basic operation
Playing records
Switch the main power switch on the backside of the turntable to the "on" position. Open the dust
cover and place the record on the platter. If you play a single, do not forget to place the single puck
first.

Set the correct RPM speed

Remove the needle protection cover from the stylus

Unlock the tone arm on the armrest

Bring the tone arm to the record, the platter now starts rotating

Carefully place the tone arm on the record. Do not forget to lower the arm lever
FIG A
FIG B
BACK VIEW OF HEADSHELL
WIRING
WHITE
BLUE
RED
GREEN
8