Grundig GHL0500 Servicehandbuch Seite 12

Allgemeiner Teil / General Section
CODING
The code number for the device can be found on the identity card.
Coding is not activated by default. If you activate coding, the device
is electronically locked as soon as it is disconnected from the vehicle
battery or the continuous positive terminal 30. It can only be
switched on again if the code number is re-entered. See also the
setting on page 23 in the "EXPERT level" section.
Activating coding
EXPERT
Select EXPERT level.
1
2 Press »<« or »>« to select »CODE« in the display.
CODE
3 Briefly press »EXP« .
– Display: »- - - -« flashes.
----
4 Enter the code number (a) using »<« and »>« or (b) using the
station buttons »1«, »2«, »3«, »4«.
a) Hold down »<« or »>« for fast selection.
Using the station buttons:
b)
Example: Code number 1703
»1« Press briefly once
»2« Press briefly seven times
»3« Press briefly ten times
»4« Press briefly three times
5 Briefly press »EXP« to confirm.
– Coding is activated.
SAFE
6 To quit EXPERT level hold down »EXP« until you hear the signal.
Deactivating coding
1 If, for example, you want to remove the device, select EXPERT
SAFE
level and select »SAFE« on the display.
28
CODING _______________________________________________
Waiting times
In order to prevent unauthorised persons from switching on the
radio and deactivating the coding by trial and error, waiting times
are set between attempted code entries. During these times the
device can be switched on and off, but it will not work.
The device does not need to be switched on during the waiting time,
but it does need to be connected to the permanent + 12 V supply.
»SAFE« in the display means that the waiting time has not yet
elapsed. When the waiting time has elapsed the number of the next
attempt appears in the display, for example »2 - - - -«. The
following table shows the waiting times after each attempt:
1. ............................................................21 sec.
2 ...........................................................1.5 min.
3 ...........................................................5.5 min.
4 ............................................................22 min.
5 ............................................................1.5 hrs.
6 ............................................................6.0 hrs.
7 .............................................................24 hrs.
8 .............................................................24 hrs.
Note:
The waiting time is 24 hours for each subsequent attempt. After
the sixth incorrect we recommend that you have your specialist
dealer enter the code.
30
1 - 12
________________________________________________
»1 - - -«
»1 7 - -«
»1 7 0 -«
»1 7 0 3«
SCC 3400 RDS / SCC 3460 RDS / SCD 3490 RDS
_______________________________________________
CODING
2 Briefly press »EXP« to activate the setting.
– Display: »1 - - - -« flashes.
1- ---
3 Enter the code number using »<« and »>« or using the station
buttons »1«, »2«, »3«, »4«.
To confirm the setting, press »EXP« until »CODE« appears in the
4
CODE
display.
– Coding is deactivated.
Note:
If you enter an incorrect code number »SAFE« remains in the
display and the radio cannot be switched on. Start again,
taking note of the waiting time between attempts. See page 27
for information on waiting times.
Renewed operation
If you activate coding, the device is electronically locked as soon as
it is disconnected from the vehicle battery or the continuous positive
terminal 30, which may be the case if the car has been in the
garage for repairs. To use the radio again you must first enter the
code.
1 Switch on the car radio.
SAFE
– Display: temporarily »SAFE«, then »1 - - - -«.
– »1« shows the number of attempts at entering the code.
1-- --
Enter the code number using »<« and »>« or using the station
2
buttons »1«, »2«, »3«, »4« (as described on page 26).
3 To confirm, press »EXP« until »SAFE« briefly appears in the
SAFE
display.
– The radio switches on.
Note:
If you enter an incorrect code number »SAFE« remains in the
display. Start again, taking note of the waiting time between
attempts (see page 27).
29
GRUNDIG Service