Setting The Clock; Selecting The Display Language; Self-Monitoring Functions Overview; 10.1 Errors During Data Input - Hürner HST 300 Print Bedienungsanleitung

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str.
35325 Mücke, Germany
"Select Language M " means that by pressing the MENU key, the
user can access a sub-menu for selecting the display and print
language.
9.2

Setting the Clock

When the "Set Clock" sub-menu was selected, the screen changes to
the display reproduced in Display 12.
The time of day and the date can be set using the keypad. The portions
"Hour," "Minute," "Day," "Month," and "Year" are set separately. Press the
START key to confirm your settings.
9.3

Selecting the Display Language

When the "Select Language" sub-menu was selected, the screen changes
to the display reproduced in Display 13.
Use the arrow keys  and  to select one of the options, "Deutsch,"
"English," "Français," "Español," and "Português" and confirm your selec-
tion by pressing the START key.
10

Self-Monitoring Functions Overview

10.1 Errors During Data Input

10.1.1 Code Error
Erroneous input, poor code tag, error in code symbology or improper
code reading.
10.1.2 No Contact
There is no properly established electric contact between the welding
unit and the fitting (check connection terminal pushed on fitting), or the
heater coil is defective.
10.1.3 Low Voltage
The input voltage is below 190 volts. Adjust generator output voltage.
10.1.4 Overvoltage
The input voltage is over 285 volts. Decrease generator output voltage.
10.1.5 Overheated
The inverter temperature is too hot. Let the welding unit cool down for
about 1 hour.
10.1.6 System Error
CAUTION!
The unit has to be disconnected immediately from the power supply and
the fitting. The auto-test has found a system error. The unit must no longer
be used and has to be sent to an authorized shop for check and repair.
10.1.7 Temperature Error
The ambient temperature measured is outside the operating range of the
welding unit, i.e., below –10°C or over +50°C.
10.1.8 Temperatur Sensor Defective
The ambient temperature sensor on the welding cable is damaged or
defective.
Version November 2010 HST300 Print User's Manual
Set Clock/Date
10:25 06.09.02
Display 19
CHOOSE LANGUAGE
>Deutsch
English
Francais
Display 13
EN
13