Dmx-Protocol - EuroLite LED ML-56 COB CW 100W Bedienungsanleitung

Please, be sure that you don't have any overlapping channels in order to control each LED ML-56 COB
CW/WW 100W 60° correctly and independently from any other fixture on the DMX-chain. If several LED ML-
56 COB CW/WW 100W 60° are addressed similarly, they will work synchronically.
If you set in the 5 channel mode, for example, the address to channel 6, the device will use the channel 6 to
10 for control.
Controlling:
After having addressed the LED ML-56 COB CW/WW 100W 60°, you may now start operating it via your
lighting controller.
Note: It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.

DMX-protocol

DMX mode:
2 channel mode
Control-channel 1 - Dimmer CW (cold white)
Decimal Hexad. Percentage
0 255 00 FF 0% 100%
Control-channel 2 - Dimmer WW (warm white)
Decimal Hexad. Percentage
0 255 00 FF 0% 100%
5 channel mode
Control-channel 1 - Dimmer CW (cold white)
Decimal Hexad. Percentage
0 255 00 FF 0% 100%
Control-channel 2 - Dimmer WW (warm white)
Decimal Hexad. Percentage
0 255 00 FF 0% 100%
Control-channel 3 - Master dimmer
Decimal Hexad. Percentage
0 255 00 FF 0% 100%
Control-channel 4 - Strobe
Decimal Hexad. Percentage
0 0 00 00 0% 0%
1 255 01 FF 0% 100%
Press the MODE button until the display shows DMX MODE.
Press the ENTER button. You can select the desired DMX
address via the UP or DOWN buttons. Confirm your choice by
pressing ENTER.
S/F
F Gradual adjustment of the dimmer intensity from 0 to 100 %
S/F
F Gradual adjustment of the dimmer intensity from 0 to 100 %
S/F
F Gradual adjustment of the dimmer intensity from 0 to 100 %
S/F
F Gradual adjustment of the dimmer intensity from 0 to 100 %
S/F
F Gradual adjustment of the dimmer intensity from 0 to 100 %
S/F
S No function
F Strobe-effect with increasing speed
25/28
Feature
Feature
Feature
Feature
Feature
Feature
00070391.DOC, Version 1.0