Trademarks; Qualified Personnel - Siemens SIMATIC NET CP 5613 A2 Produktinformation, Installationsanleitung

Trademarks

SIMATIC  , SIMATIC NET  and SINEC  are registered trademarks of Siemens AG.
Third parties using for their own purposes any other names in this document which refer
to trademarks might infringe upon the rights of the trademark owners.
Safety Instructions Regarding your Product
Before you use the product described here, read the safety instructions below thoroughly.

Qualified Personnel

Only qualified personnel should be allowed to install and work on this equipment . Quali-
fied persons are defined as persons who are authorized to commission, to ground, and to
tag circuits, equipment, and systems in accordance with established safety practices and
standards.
Correct Usage of Hardware Products
Please note the following regarding the correct usage of hardware products:
Caution
This device and its components may only be used for the applications described in the
catalog or the technical description, and only in connection with devices or components
from other manufacturers which have been approved or recommended by Siemens.
This product can only function correctly and safely if it is transported, stored, set up, and
installed correctly, and operated and maintained as recommended.
Before you use the supplied sample programs or programs you have written yourself,
make certain that no injury to persons nor damage to equipment can result in your plant
or process.
EU Directive: Do not start up until you have established that the machine on which you
intend to run this component complies with the directive 89/392/EEC.
Product Information/Installation Instructions CP 5613 A2, CP 5614 A2
A5E00779184
27