Contents
en
Congratulations on the purchase of your
new Bosch appliance.
You can find further information about
our products on our web page.
Contents
Intended use . ............................................14
Overview...................................................16
Operation . .................................................17
Recipes.....................................................20
Disposal . ...................................................23
Guarantee.................................................23
Safety systems
Start lock-out
The appliance cannot be switched on until
the blender jug has been turned firmly into
place.
Automatic disconnection
The appliance switches off automatically
if the blender jug accidentally becomes
detached during operation.
Overload protection
If the motor switches itself off while the
appliance is being used, the overload pro-
tection feature has been activated. Possible
causes:
- very large amounts of ingredients,
- appliance operated too long.
If a safety system is activated, see
"Troubleshooting".
16
Overview
These operating instructions refer to various
models. Please fold out the illustrated pages.
1 Motor block
2 Rotary switch with illuminated ring
The illuminated ring flashes slowly when
the appliance is ready for use (on). The
illuminated ring is lit continuously when
the appliance is in operation. Rapid
flashing signals a fault (see "Trouble-
shooting").
Stop
P
Appliance on
on
Lowest speed
min
Highest speed
max
Q Pulse circuit at maximum
speed. Hold down switch for
required duration.
3 Quick-selection buttons
Preset buttons for optimum results.
for crushing ice cubes (crushed
T
ice). Press button 1x briefly.
For making mixed drinks
U *
and smoothies. Press button
1x briefly.
For an even more delicate
result, press the button a
second time.
V * For cutting ingredients in the
universal cutter. Press button
1x briefly.
Pay attention to Figure F in
the table!
For making mixed drinks and
High
smoothies. Press button 1x
Speed
briefly. The appliance runs
with a speed that is up to three
times higher.
When a quick selection button
(T/U/V/High Speed) has been
pressed, the preset programme runs.
To end the programme early, press any
quick-selection button or turn the rotary
switch to 0/off.