Installation; Technical Data - profiline TV7328 Installationsanleitung

10. Installation

Proceed as follows when installing the camera.
1. Select a suitable place to mount the camera.
2. Connect the video cable (recommended cable type: RG59) with the BNC video output of
the camera and the device directly connected to the camera. The maximum cable length
must not exceed 200 m.
3. Connect a power supply to the camera.
4. Hold the camera at the location where you want to mount it. Check the orientation and
angle of the camera.
5. Select the required settings in the camera's programming menu.
6. Set the required zoom range.
7. Fasten the camera. Make sure that the camera when outdoors has sufficient protection
(e.g., heated, weatherproof housing).
8. After completing your settings, push the protective cover over the keypad.
Threaded hole
Fixing
screw
Use cable clips to ensure sufficient
pull relief of connection cables.

11. Technical data

Model number
CCD element
Number of pixels
TV lines
AGC range
Gamma correction
Light sensitivity
Signal-to-noise ratio
Resolution
CTF modulation
Electronic shutter control
Video OUT
Power source
Power consumption
Video norm
Lens holder
Dimensions / Weight
Ambient operating
temperature
Ambient operating humidity
Lens holder
These operating instructions are contained in:
Instal TV7328-TV7329-ver.01_20051115.doc
49
TV7328 TV7329
1/3" Interlace SONY Super HAD CCD
542 (H) x 582 (V) pixels
380 TV lines (colour)
36 dB
0,45 – 1
0.35 lux @ 30 IRE F1.0 (SAGC on)
175 lux @ 100 IRE at sensor
60 dB @ 100 IRE AGC Off
50 dB @ 30 IRE AGC Off
380 TV lines @ 100 IRE AGC Off (colour)
310 TV lines @ 30 IRE AGC Off (colour)
11% at output signal @ 48 TV lines
1/50s – 1 / 100,000s
2 x 1Vp-p / 75 Ohm / BNC plug connector
12 V DC or 24V AC 85 ~ 265 V AC
4.8.8W (DC) 6.0 W (AC) 6.0 W (AC)
PAL
1/3" C or CS mounting
H: 52 x W: 71 x D: 140 mm / 345 g
-10 °C – +50 °C
max. 90 % non-condensed
C/CS holder