Precisa XM 60 Serviceanleitung Seite 92

Series 330 XM
9. Cleaning
9.1 Cleaning the magnet
1. Cut strips of a double-sided adhesive tape (ca. 2x2 cm).
2. Wind the adhesive tape around one end of a toothpick.
3. Introduce the toothpick, adhesive tape first, vertically into the annular gap.
4. With circular movements move it repeatedly around the magnet. In this way any dirt particles stick to
the adhesive tape.
5. If necessary, repeat the procedure with a freshly prepared toothpick until the annular gap is free
from impurities.
6. Wipe over the top of magnet with a piece of adhesive tape.
9.2 Cleaning the coil
1. Using a lint-free cloth, remove any contamination from the coil.
2. Do not clean the coil with adhesive tape; risk of injury!
9.3 Final check of cleaning
1. Visually inspect the annular gap and the coil for any contamination and clean if necessary.
Precisa Gravimetrics AG Index b4
Cleaning
D20