Vacuuming with waste hose system
(LP appliances)
Perform the suction process.
The vacuumed material only falls into
the waste hose when the device is
switched off.
Check the filling level of the waste hose
at regular intervals, as the device does
not shut off automatically.
With light waste or in case of clogging:
Pull out the sheathed cable to open the
flap on the outlet (only possible when
the device is switched off).
Slightly pull down the waste hose, close
it with 2 cable ties at a distance of 10 cm
and cut it between the cable ties.
Dispose of the waste sack in accord-
ance with the legal requirements.
Note: With light waste the length of the
waste sack can be up to 2 m without it
bursting.
Indicator lamps
Lights up when the suction turbine is
running
Blink codes for the remote control train-
ing time (IVS 100/55 and IVS 100/75)
Green
Remote control
The appliances
IVS 100/55
IVS 100/75
are equipped with a radio receiver for the
remote control option.
The training time and operation are de-
scribed in the operating instructions of the
remote control.
Shutting down
Switch off the appliance using the On/
Off switch.
If necessary, dismantle the accessory
and rinse it with water and let dry.
Empty the vacuuming material contain-
er (refer chapter "Emptying vacuuming
material container").
Vacuum and wipe the appliance inside
and outside with a damp cloth.
Emptying the vacuuming material
Note
The vacuum material container must be emp-
tied when it is has filled up to approx. 3 cm be-
low the upper edge.
Switch off the appliance and secure it
using the parking brakes at the guide
rollers.
Open the vacuum material container
upwards at the unlocking mechanism.
Pull out the vacuuming material con-
tainer from the appliance using the han-
dle that has been provided for the pur-
pose.
– 5
EN
container
17